looking to get my swift springs installed, but i have no clue what im doing or have the tools to do so. so i was wondering if someone on here can possibly install the spring (of course i would pay), or a shop that can do it for me ( a good shop i can trust)..

thanks

 

Just rent a spring compressor, its not hard to do. Revhi's shop can do it I bet.

 

Don't even need that w/ 2 people.

 

jay.. jeremey and i did my spring install in about 2 hours.. the front was super easy.. it was the back that was a pain in the ass. especially the left side. Because you got the fuel tank assembly right over the rear strut.. You deff need someone helping to do the rear cause theres times you gotta pull down supper hard on the hub or w/e to get stuff lined up trust me. other than that it wasnt to bad.. I payed like 175 to do them at my job.. only good thing was i got payed to do them so i payed myself kinda..

 

thanks everyone...ill look into doing it myself with some help , but i ll still try and find a shop to do it

 

jay if i can get you on base at fort dix me and june will do it, just let me know when and i can poss set something up, and since your in pemberton you're right around the corner

 

oh YEaaaa

 

Good luck after what happened yesterday.

 

talk about bad timing

 

I should still be able to help out either way if we do it where i work or at someones house on a sunday or something