Looks good!! Nice Job

 

Greart news I can ship these in the US. for $299.00 Local pick up is only $245

 

I wish it fit the CR lip. I would buy one.

 

It may, measure across the front end of the car, from one side to the other, just in front of the wheel openings where the canards are in this pic.


The splitter is made a bit wide on the AP1 as you can see. On the CR the canards will be right to the side of the spoiler with little to no gap.

 

COT lookalike

 

Perfect for autoX: it would just slice the tops off the cones!

 

the lip on the CR is not flat across the bottom. It is higher in the middle than it is on the sides so it would leave a gap.

 

Hmmmm I think this is a fake copy! I used to know a guy about a year ago that made pretty much the exact same thing!

 

That might look pretty bad a$$ I need a CR near by to test fit
Hey, I am coming over your way on Saturday to help Willie G with a diff install. Maybe if you have time swing by and we can see how it will look on the car


[QUOTE]
Brownsound Posted on Dec 10 2008, 12:56 PM

 

It's probably pretty useful in smoothing out grout too.