Only 2 are remaining out of the 3 left over PuddyMod ETD mounts. $30/$50 These mounts are left over from the first run I made. They are the old style and discontinued, I no longer release these to my vender. The one in the back ground is my first prototype and all three holes are taped for bolts. The other two (now only one) are production units and only taped for the one bolt hole at the top left side. The other two holes use the nut bolt combo. All three are taped for the damper bolt. $30 each for the two production units and $50 for my first prototype. This is a great mod that will save your car from you having to yank off the fuse box mounting tab in order to install an ETD.

 

Don't need anything, but bump for da Puddy!

 

ill take the clutch disc if it falls through

 

I will let you know

 

Ztec cover sold
Still have not heard back from the other guy I will give it till Tuesday

 

sent you a pm for one of the ETD's.

 

Flywheel sold and one PuddyMod mount sold
2 are still up for grabs
My personal prototype, the first ever made and the only one I made with all three holes taped for 6 mm screws. You can top mount this one in 5 minuets. The other one is the last of the ready to powder coat finish. It is the one I used to aid in the design of the V-2, this is why there are measurements wrote on it. I will clean it off before I send it out

 

Eric, it is put away for you

I am locking the thread, I only have the prototype left. I will offer it latter with an OEM heat shield cut and ready to go and a new PuddyMod ETD

THANKS FOR LOOKING