I opened my motor to install AP2 retainers and found an absolute mess. The rear-most intake cam cap is damaged and needs to be replaced. I will also need an AP1 intake cam.

I need the top and bottom parts of cam cap #5 as well as an AP1 intake cam. Please PM me your best price shipped to 30132.

Thanks for the help.

Drew

 

to install this properly you have to get that cam cap line bored, which is expensive. you might look into replacing the entire head.

 

Are you sure? Do you have specific knowledge to the f20c? Both the top and bottom parts of the cam cap are independent from the head so it seems like you should be able to replace only the damaged pieces.

Sure, you'd need to make sure everything is within tolerance, but I can't logically understand why you couldn't just swap in fresh parts...

Please elaborate?

 

The bottom portion of the cam bearing surface is integral with the head. It is not removable/replaceable.

DumpedS2k is pretty much correct. You can pick up a new (used) head for $3-500 depending. That's your best route.

 

It can be removed from the head. The bottom half of the cam bearing surface is part of the rocker arm assembly. Please review pg 6-30 of the Honda service manual.

Anyone with an extra valve train assembly please contact me w/ pricing.

I'll also consider purchasing a complete head to expedite this process.

Edit: Sorry, misunderstood what you were trying to say. Yes, the cam is damaged and will need to be replaced as well. Thanks to Clark for the further help.

 

My bad, you're right. posting while tired, sorry.

 

i have the complete rocker assembly with cam caps let em kwno thanks

 

I also have the complete assembly w/ cams!

 

Thanks guys. I think I've sourced a set but if not I'll be in touch!

 

Purchased. Thanks Jimboner!