Got a few PMs from people purchasing the unit. Thought I'd get around to posting an install DIY. Couldn't find my digicam, so will have to settle for crappy cell phone pix.


--CKit









"Scotchlok" T-taps. Put one wire through and one unstripped wire alongside.
Clamp the metal bridge down and lock the cover over and the wires are spliced together. Solder if you'd like for more stability. Cover with electrical tape.







You can tap into the ACC fuse or into the ACC power wire (green wire in diagram is tapped to power).

The ECU has three wiring harnesses. Front to back are "A," "B," and "C."
"A" has the blue #19 wire for the tach. "B" has the injector cut wires. You don't need to tap into the "C" harness. Refer to the wiring diagrams posted above for the coloring of the wires to splice into.








For the ABS wires, it doesn't matter which color wire goes to what ABS sensor.

 

PM me when this is complete.

 

i've already told you through PM, but i figured i will put it here as well. i have every intention of trying to do this install this week/end. thanks again for doing this!

 

If you guys don't mind, please snap pics, and make a few notes.....or a bunch of notes

Thanks
Brad

 

post pix. lots of them. i wanna see how you cut into the abs wires

 

i too am very interrested in a diy

 

Some pictures posted. The ECU wires aren't labeled in the pictures yet.
Also have to get a picture of the ACC power and grounds.

But it should be a place to start.

 

PM with questions.

 

very nice! i just printed the page so i could refer to your pictures.

an additional note, here are the pages for the wiring diagrams (from service manual for 2000-2006)
Connector A: 11-17
Connector B: 11-19
ABS: 19-37

 

excellent write-up