Did you ever get these installed???


I am thinking about going with these with mugen rails.

 

I can't wait til I get my hand on the Bride Gias

 

I had a Straida in my 06 about 9 or so months ago... here is the forsale post.

https://www.s2ki.com/forums/index.ph...pic=384611&hl=

It was an amazing seat... however I have a 36 waist and it was too tight of a fit. 34 and down

 

is it really that tight?

 

what is the inside hip width???

 

I didn't get to measure the inside width... but it was too tight of a fit for me. I wear a snug 36, maybe you could say a 37 and it wasn't comfortable for me.

For comparison I fit in a Recaro Pole Position. I drove from LA to San Francisco and back in a Civic and it was a dream.

 

http://tees-usa.com/size_bucket2.html

From the chart it doesn't seem that bad

 

That does not tell you the inside width
that tells you the outside shell dimension


For an example the Race tech 4009WHR seats have an out side dimension of 17.5"

However this is not the actual dimension where you sit its actually 16.5"

Same conventions hold true for the Bride seats.

I have a 38" Waist and can fit into the Raceteach seat but AP2_s2k said he could not fit into the Bride sat and he has a 36" waist.

So something is just not adding up.

All I want is someone to go get a tape measure and measure the width when the padding is compressed.

 

430 near the rear, and 420 near the front

 

now that