OK, Sunday, 11am. I'll PM my address to those interested.

Bill

 

Hit me with the pm, Mr. Bill

 

brake pads are super easy... however, the rears gave me and dylan some trouble

bill, i will give you a call and maybe swing by. need me to bring anything in terms of tools? c-clamps? i will bring a case of beer for sure. didnt get u one when u helped me with the fluid changes

 

ygpm

 

I'm good on tools, thanks Dan

 

I'm going to have to play Sunday by ear, but if I can swing by for a few minutes I will (since you're just down the street from me).

I'll throw my caliper piston spreader in the trunk if I can swing by

 

thanks for the pm and i'll see you all on sunday! ill bring some beer. and grilling sounds great since its been so freakishly cold these days..

 

oh and Bill i hope you didnt forget that i needed rotors done too right?

 

I might have it's all good though.

 

Well, it was a somewhat successful maintenance/mod day at Bill's. Except...

- 1/2 of axle nuts replaced before this happened:


- RioS2k's sway bars... Well, they shipped two fronts. So I took the extra

- Swallow's ball joints wouldn't pop

- Rio's lock screws on his rotors wouldn't loosen up. Bill had to drill 'em out.
I did one side and Bill did the other. Then I accidentally installed two outside pads on the rear rotor... We fixed it before putting it all back together

- Bill went to fire up the grill for burgers and he quickly ran out of propane

Here are a few of the relatively worthless pics I took





This is absolutely BRILLIANT!










Good meeting everyone! Special thanks to Bill!