i just took new pics of my car at cameron university. i thought they came out pretty good, so i just wanted to share them.

the back:




the engine:




the side:




interior: (not much in there)

 

Likey...
I noticed you ARC and have some comments. If installed properly, it acts somewhat like a ram air. I would guess that a lot of people install the unit like you have done. Let me guess, the back arm support just "did not fit" so you blew it off?

It actually does fit. However, the side air wall requires slight modification to fit properly under the hood. I can tell you that I have had my ARC installed both ways...there is a difference. When angled at the proper angle, air is sent much more directly into the unit - less of the 'hot air intake argument'

Perhaps I can share some photo's if you are interested in learning more.

BTW, have you needed to clean your ARC at all? I need to do it, but am not clear if there is a proper procedure?

 

yeah, any extra advice would be cool n pics too. i've had the arc intake for 3 1/2 yrs and i've cleaned it twice. i just use the k&n cleaning kit; i works just fine.

 

Where were you at this weekends meet?

 

where was it? if it was further from lawton than okc im not driving that far. laziness i guess and/or the fact that its rough with a race suspension on these crappy roads. but seriously, i missed it, cuz i mustve not seen the post.