I recently purchased the Bee-R rev limiter for my 05. My ground, power , and hand brake wires are tap in. I would like to know where the green and hello wires tap to. I have read the instructions and seen some pinouts. I had the green tap to pinout A19. And then yellow to C8 (wouldn't start) then C9 (Bee-R turns on but I could rev freely) Also with the units Rev 1 and 2 at 0, should limit at 2500 (what Bee-R says to do after install to verify) please I don't know which wire is the appropriate one.

 

Bunmp