No Rpm reading at tachometer but ECU reads RPMs
Thread Starter
Registered User
Joined: Oct 2017
Posts: 7
Likes: 0
No Rpm reading at tachometer but ECU reads RPMs
Need help. Dropped the subframe to replace the main seal on my 01 s2000. Put everything back together, and now my tachometer isn’t reading.
I was careful not to stretch wires. I plugged my laptop into the ECU and it shows my RPMS. So I took the dash apart checked the signal with my electrical meter at the solid blue rpm wire and it just steadily beeps at me.
I then traced it to the A connector at the KPro (A07 ECU) and again, just beeps at me. I took the KPro apart and all looks good. Any ideas?
I was careful not to stretch wires. I plugged my laptop into the ECU and it shows my RPMS. So I took the dash apart checked the signal with my electrical meter at the solid blue rpm wire and it just steadily beeps at me.
I then traced it to the A connector at the KPro (A07 ECU) and again, just beeps at me. I took the KPro apart and all looks good. Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
Mxkidd125cc2004
S2000 Under The Hood
4
Aug 5, 2019 06:10 PM
Mxkidd125cc2004
S2000 Engine Management
0
Aug 3, 2019 04:36 PM