AEM Serial Gauge - How to set parameters per conditions?
#1
AEM Serial Gauge - How to set parameters per conditions?
I know the serial gauge topic has been beaten to death in the past. most of those threads were on basic sensor wiring and setting up the look up tables.
I have the gauge set up and working with the basic high and low limits set on multiple sensor inputs.
I am trying to figure out how to get high and low limit warning to only trigger under given conditions. For example, say i want oil pressure to trigger a low alarm if it falls below 30 psi only when the engine is at 2000rpm or higher.
I have searched this topic up and down. The gauge software sucks. I've spent countless hours on setting up what i have and refining as i go. i have done many many many trial and error attempts to get this to work.
Any help would be greatly appreciated. I know someone out there has to have this information.
I have the gauge set up and working with the basic high and low limits set on multiple sensor inputs.
I am trying to figure out how to get high and low limit warning to only trigger under given conditions. For example, say i want oil pressure to trigger a low alarm if it falls below 30 psi only when the engine is at 2000rpm or higher.
I have searched this topic up and down. The gauge software sucks. I've spent countless hours on setting up what i have and refining as i go. i have done many many many trial and error attempts to get this to work.
Any help would be greatly appreciated. I know someone out there has to have this information.
Thread
Thread Starter
Forum
Replies
Last Post