Wiring in AEM EGTs to ECU
Thread Starter
Registered User
Joined: Sep 2009
Posts: 420
Likes: 0
Wiring in AEM EGTs to ECU
I have 4 EGT sensors with my kit, 1 in each exhaust runner. I wired them into my AEM series 2 ecu according to the instructions. The RTD sensor instructions said polarity is not important.
My problem is that in the AEM ecu it reads all the sensors as 0.10-0.14 volts. instead of whatever it really should be... Anyone else run into this problem?
My problem is that in the AEM ecu it reads all the sensors as 0.10-0.14 volts. instead of whatever it really should be... Anyone else run into this problem?
Registered User
Joined: Jul 2007
Posts: 502
Likes: 0
From: Tampa, Florida
I have 4 EGT sensors with my kit, 1 in each exhaust runner. I wired them into my AEM series 2 ecu according to the instructions. The RTD sensor instructions said polarity is not important.
My problem is that in the AEM ecu it reads all the sensors as 0.10-0.14 volts. instead of whatever it really should be... Anyone else run into this problem?
My problem is that in the AEM ecu it reads all the sensors as 0.10-0.14 volts. instead of whatever it really should be... Anyone else run into this problem?
Thread
Thread Starter
Forum
Replies
Last Post