hello

i need to get a 4" turbo intake pipe and filter of my turbo. does any one make one?
oh yea, it for a lovefab mini manifold set up.
thanks

 

buy some 4inch tubing and cut it to size. Or ask Lovefab if they make it.

 

same here, im using a 3076R with the 4" inlet. I was wondering what part #'s you all are using for the k and n filter...you can find 4" bends in stainless at summitt racing or jegs as well..

 

just went on summit racing, found a k and n filter for 38.00 part # RU-2520. this is a 4" inlet, and is only 5 inches long...so its small and flows 900cfm...so more than enough. Im still trying to find a bend for the intake though...

 

I'm using the HKS 200mm filter with 100mm inlet... flows as well as no filter at all.

 

I've never used air filters....

Window screen w/a hose clamp ftw.

 

or you could get a 4 to 3 inch connector and run 3inch piping, which is usually easier to find

 

how long have your turbos lasted? i did the same on racecars but never on a street car.

 

care to show us where you bought this?

 

bought it here. $90 make sure you change the pipe size to 100mm.

http://www.frsport.com/HKS-SMF-Reloaded-St...0mm_p_9383.html