I was wondering if anyone could offer some information about drag wheel(slicks and skinny) sizing on the s2000. I am looking into picking up a set of 17" front skinnys and 15" rear wheels. I know kings and some other vendors sell the Weld RT-S and dont disclose the backspacing and widths. Can anyone confirm what sizing will work best on the S? Thanks guys.

 

https://www.s2ki.com/s2000/topic/104...nd-tire-setup/

Some good Info here.

 

Not to thread jack but anyone know if theirs skinnys out their that will clear endless 6 pot calipers?

 

check out http://www.championbillet.com/ if you dont feel like spending a mortgage payment on some wheels.

 

Buy my 17" skinnys there shaved and painted I went a different route
Also my 15x8 slips for the rear they clear great cheap drag pack
Sent from my VS870 4G using Tapatalk 2

 

This^
I have champion skinnies on my car and they were much much cheaper than almost anything else out there and they are built to order and custom backspaces. I had to run spacers on the from with stock brakes for my 15s but they still fit in the fender and with the willwood brakes on my race car they clear with 0 spacer.
I will be ordering my rears from them soon because the fronts fit so nicely and were so much cheaper than welds. I just need to figure what backspacing I'm going to need for my race car at 14" wide lol

[attachment=64924::] [attachment=64925::] [attachment=64926::]

 

Years back i was looking into getting a set of champion wheels but they didnt offer anything that would fit the s2k rears backspacing wise?

 

they will make whatever back spacing you want

 

They have come a long way over the past couple years, you can get whatever backspace you want like redboost already said

 

Wow the at champion I spoke to said they couldn't lol. Looks like i might be giving champion a call in the future then wasn't aware of that