I have a full blown manifold which is super tight to the oil pressure switch,how have people got round this ?

thanks

 

Many people will replace the sensor wth a bolt of the same thread pitch. The actual sensor isn't used with stand alone ECUs anyway.

 

so using the aem v2 will be fine the blank off ? Does this effect VTEC or any thing ?

 

No AEM just throws a signal to turn it on and off... it does not care about oil psi.

Hit me up if you need any AEM help

 

oh thank you so much I’m in the uk

 

Your suppose to take out that sensor and just screw a bolt through the hole. Most of these manifold assume your going to running an aem ems which do not used that sensor to activate vtec. I thin you will need a short stubby 10x1.25 bolt.

 

thank you

 

That's fine, I tune guys all over the world.