got the exact specs-
skunk2 stage 2 NA
intake- 272/0,53 lift@0.000 lash
exhaust- 278/0.551 lift@0.00 lash

 

Will you be running adj cam gears too?

 

negative

the overlap was a concern to me as well, I brought it up to them and they told me gears werent needed but were being developed so im sure ill be running a set soon

 

Can't wait to see dyno results.

 

to make power with the cams you have to get the car tuned for them

 

are you going to do a before and after dyno results

 

thats the plan im built from head to toe

 

Can you post specs and dyno sheet on your current setup? Or are you not done with your build yet?

 

Block-
Cp pistons
AEBS T sleeves
Pauter rods
ACL bearings
micro polished crank
still stock bore

Head-
Ferrea valve train
1mm Oversized valves all around
port and polished by vinny ten

Turbo-
Gt1 turbo kit
4 inch dp
tial 44
tial bov
turbonetics t72 BB

fuel-
twin 255 walbro intank pumps
x2 -6 lines for twin feed fuel rail
aeromotive FPR -6

EMS-
AEM EMS
AEM ingnition driver
CBR 954 coils
5 bar map sensor
GM boost solenoid

 

that turbo's a huge bitch!