Hey, I have a question about hooking up the emanage and I cannot get a hold of greddy. I have just recently installed the greddy kit along with many other mods to support the extra horsepower. But my question is for those who have delt with this kit, is when hooking up to the ecu the jumper harness for the e-manage has 4 plugs but the ecu only has 3 outlets for these plugs and one of the e-manage plugs are not used. So I have not started my car yet just waiting on my bov to be welded to the piping and and will be ready to go, but I just wanted to know if I leave that plug blank or does it really go to something?

 

DONT WORRY ABOUT THE 4TH ONE,JUST MAKE SURE THE ULTIMATE DOES NOT HAVE A FLASHING RED LIGHT

 

thanks, I saw that in the manual, I just wanted to see if anyone had any experience with it before I try to start her up on friday.

 

yeah the 4th plug isn't used...

 

Just curious as to what other supporting mods you have to make extra hp for this kit?

 

well the other mods I have just installed to help out with the extra power are a new exedy hyper single clutch/flywheel combo that I installed (tranny was a pain to take out), also I have add a new rear with richmond 4.56 gears with a reinforced comptech housing, and I switch out my invidia exhaust for a J's 70rr titanium and a couple other little things here and there.

 

wideband to monitor how ur a/f are doing/ spark plugs

 

I dont have a wideband but I have a a/f ratio gauge and I am using the colder greddy plugs

 

but I will be getting the aem wideband after talking to the shop that will eventually tune my car, thanks for the tip.