Quick story on this one....

i had a yellow S2000, which was stolen and wrecked. Well i had put a CF hood on the yellow S2000 and the yellow hood sat in my garage.
One day i was cleaning out the garage and found it, and i had seen someone else did this idea, so i did it to. kept my original hood black and repainted the yellow on black also, with gold mesh to match my rims and jolly roger decal





p.s. excuse the dirty car and garage, just got the car back from the shop. (broken wheel bearing )


UPDATE PICS

Here's some outdoor daylight pics.

 

I thought those were just some reflection coming from your lights.
probs for your hard work.
more pictures of your whole car would give us better idea though.

 

what kinda mesh are you using?

 

Corrosion-Resistant Aluminum Woven Wire Cloth, 6 X 6 Mesh, .035" Wire Diameter, 24" X 24" Sheet

basically alot of little square holes, i like it more then the diamond pattern. and it was only 25$ shipped from mcmaster.

i purchased it from www.McMaster.com

Close up of the mesh to show the design.



24"x24" is more then enough to do one side, i bought that much for the day i do the other 3 holes if i wanna

ya, as soon as i clean the car and stuff tommorow, ill be out at night for some photo's of the whole car

 

idk looks good on some cars.. but idk. at least u didnt do both sides.. one side looks 1000x better than both.

any better pics by chance?

 

ill have better pics tomorrow, cars dirty, and i dont wanna show off a dirty car

 

I dont care for the mesh color but I dig the hood.

 

i think the mesh would look better in gunmetal grey. but nice work and a for your hard work

 

thanks



only reason i picked gold was to match my Rims and emblems.

going for a 2 tone gold on black

 

bump for new updated pics