New/Final setup for 2011!
Registered User
Joined: Jul 2010
Posts: 628
Likes: 0
From: San Diego CA
From on Pearl S2000 owner to another, I 
your car. I'm a sucker for Pearl Paint. 
I can't believe Honda didn't offer this color in the U.S. Makes the S look super classy. I like the splitter, but it just seems a little big. How do you like it, does it get caught on driveways?
your car. I'm a sucker for Pearl Paint. I can't believe Honda didn't offer this color in the U.S. Makes the S look super classy. I like the splitter, but it just seems a little big. How do you like it, does it get caught on driveways?
Registered User
Joined: Dec 2009
Posts: 2,396
Likes: 0
From: Auburn Hills, Michigan
This is being picky since your car is already nice!
but imo, im always iffy about full diffusers in the back like that with only a single exhaust. Seems like a meaningless, unbalanced gap on the left side. but other than that, It looks wonderful with the rims and two-tone hardtop!
nice job
but imo, im always iffy about full diffusers in the back like that with only a single exhaust. Seems like a meaningless, unbalanced gap on the left side. but other than that, It looks wonderful with the rims and two-tone hardtop!
nice job
Thread Starter
Registered User
Joined: Dec 2006
Posts: 7,195
Likes: 0
thanks for all the comments guys, good or bad, i am pretty satisfied with where it is at for the time being. it is always a work in progress as time and money allows. so many of the things that have been suggested have already been planned for and soon to be addressed.
to address the questions about the front splitter, yes it is custom made i made it myself. more details are in the build thread. the logic here was build it bigger then i need it to be, and i can always keep trimming it down to my needs, whereas if i had build it too small, there wasnt adding to to it. i have trimmed it down once already, and plan to trim and reshape it one more time, and send it in for paint to match my berlina top 
i wish you were local! we could do a shoot together! would be awesome
it is a one off gtmotoring exhaust, headerback with a resonator and no muffler
these are the new updated brackets, actually i have modified to bring the center even higher than the updated brackets allow. i was the original person that bought the diffuser and brought it to evasives attention to get voltex to build everyone the new brackets.
i am not a big fan of the support rods but thanks!, i dont think i have the same problem. everything is tied into the chassis of the car is very secure. i built it like so...
already picked up an AP1 rear bumper, but i am contemplating if i want to go this route. the bumper is a lot boxier so i am not sure how it will flow with the trunk quite yet, but if i do decide to put it on i will get the single exhaust cap etc.
thanks!
it is a one off gtmotoring exhaust, headerback with a resonator and no muffler
looks....exactly like my splitter haha. you need to cap off the edge and you are money!!! oh and btw I have some apr support rods that you should def run for it if you want them, lots of air will be pushing it down while you drive since its so big, had that issue with mine. Just shoot me a PM
This is being picky since your car is already nice!but imo, im always iffy about full diffusers in the back like that with only a single exhaust. Seems like a meaningless, unbalanced gap on the left side. but other than that, It looks wonderful with the rims and two-tone hardtop! nice job
thanks!
