Right now I have a 245, Just wanted to run it to make sure I had enough clearance. I think I can get away with a 255, Though it will be close.

I'm still working on the rear bumper. Already relocated the mounting bolt and shaved the bumper, but still need to shave the bumper a little more.

 

I have 255's on the rear and it will rub if the fenders aren't rolled

 

Yea, Mine would rub with 245 if they weren't rolled. I am pretty low too, so thats some of my battle.

 

How low are you??

I am gonna be running a 255 and I relocated the bumper tabs today and trimmed the inner fender flush to the quarter and I am running -2 camber in the rear. I just hope that I clear. I am dropped about 30mm

 

I hope mine clears, all my info is in my post above. How cloase are you? rolled? negative camber? how low?

 

Mine finally came in

here they are

 

sizes??

 

17x8 +45 215 tire
17x9 +45 255 tire
I trimmed the inner rear fender flush to the quarter to get hese to fit and I am running -2 camber. I have about 5mm of clearance when the wheel is compressed all the way

 

Who do I need to speak with to get these RPf's in custom back spacing sizes? I want their 17x10 for the rear but its only advertised in 18mm back spacing. We have so much more room on the inside.

9" in front would compliment. Suggestions on who to contact? Thanks!

 

I know alot of the guys at Enkei so i can get that info prob, but im pretty sure you need like 100+ sets.