^^^ Just checked out your fender flare thread, can mos def appreciate your ride more for the diy.

 

Sp you can get 2 styles? Convex and concave?
Or is it just the width and offset that make it look like that?

 

^It's the width that determines the face. All of the wheels 8.5" and down have the convex face. All of the wheels 9" and wider have the concave face.

 

I dont use the centercaps that came with the wheel, i am willing to let them go for 80$ Shipped and paypaled anywhere in the US or CAN

 

Anyone selling 17x9 +45 17x9.5 +38

Please pm me before next week , when I will order new

 

What degree camber are you at in the rear? I was at -3 with my 17x9 +45's but there's no way I will not rub at my height now (1 index finger snug). I already shaved the rears to my comfort level so I would rather run a bit more camber than pull/flare the rear fenders.

 

I'm at -3.4 out back and it was a pain to make them fit and not rub. If I was ordering again I'd have just stuck with the 17x9 +45. I ended up having to pull the quarters a little more which I really didn't want to and also shave the rear bumper quite a bit more.

My rears are also at less than a finger gap.

 

Before my fender work, I ran -4 with a 245/40 at about a finger gap on my 9.5" +38.

 

Yikes... I was seriously looking at running the 18x9.5 +45 setup (235/255) that gives an extra quarter inch clearance. I do not really wish to run crazy camber or really tear up the fenders and rear bumper. I am not planning on being dumped though, just slightly lowered.