I was wondering if anyone had a pic of the beam pattern of stock HID on a wall. Im trying to adjust the headlights, but Im lowered and it hard getting an ideal height. I didnt bother to look at what the pattern was before I started and the UTH faq thread drawings do not seem right. They show the left and right pattern being even, but that makes my driver side seem to high.

 

Driver-side should be just a tad-bit below the passenger.

 

''''''''''''''''''''___________
________/__/

They say it should look like that

I think it should be like this.
''''''''''''''''''''''''_________
''''''''''''''''___/
______/

I wanted to see if anyone had a real pic of what the stock pattern looked like.

 

LEFT is always lower than the right... i guess that way you dont blind the oncoming traffic..

 

f the traffic i think it should be dead level. but its impossible since both side have the -\_

 

Hooked up like a .

http://www.modifry.com/freebies/old/zenon/index.htm

 

to blinding cars coming in the opposite direction

 

Thanks freq.

Thats what I thought, but when you look at the lights dead on, and start bending down, the driver gets brighter first indicating its higher.

That and I did the whole 25ft away measure center headlight and 2.1" down of the lowest point of the beam on the wall and the lights still seam to be aimed up. While driving down the highway I can see the beam on the dividing barrier angling up.

 

incorrect


should look like this

 

nice pics guys.... miss the S2k lights...