I googled high and low and found very few pics. Does anyone have this set up?

Also...if you have it on your AP1 that'd be even better. I'm thinking about doing that to mine, but I want to see what it looks like before I do.

 

Back when I had the Mugen lip AP2 added a splitter to protect it.




Pic on AP1

 

Here ya go!

 

If you're going to run the Mugen lip, some company makes matching sideskirts and rear pieces similar to the original C-West ones.

M&M Honda runs them on their car, I'm going to try and link a picture form their Facebook:



I think those look way better than slapping some carbon piece on the side of your car.

 

holy cow that looks good!

 

Holy crap that actually does look amazing. Any idea on what company makes those?

Thanks everyone!

 

I'm pretty sure it's M&M Honda. They make a lot of rad stuff.

Let me go through my newest Hyper Rev tomorrow and see if it's listed anywhere.

 

You're the best Feezy thanks!

 

those side skirt is clean and matches very well with the mugen lip

 

I did a bit of research, and I was just going to give it to you the next time I saw you but I figured since we already started the topic might as well post the information here.

If you look at issue #166 of Hyper Rev you will see the following:

Page: 104. It's the M&M Honda car with the Mugen front lip, the side pieces, and the rear pieces that are posted above. I can't read Japanese so I don't know what specifically they are. Any shop that can source these parts should have one of these magazines on hand. Just reference what I posted above and they should be able to start tracking these down. I have a feeling these are M&M Honda parts, but you'll need to confirm that. There is a shop locally who can order things like this for you. We can go visit him sometime when you're ready to buy em.

Also, in the same magazine there is something else that i noticed. If you look on page 2, 50, and 150 there is a front lip by a company called Seeker. I'm going to try to link to an image of it here:







It can be purchased here:

Seeker Front Lip

That lip is a good alternative to the Mugen front lip. It's similar, but it has a different design on the sides. I think it will look good with the side and rear pieces that I posted earlier as the design is so similar. There is also a little flare on the outer edge of the Seeker piece that might really look sharp when coupled with the side pieces.

If you need any more help just let me know.

Edit: If you do decide to order this stuff hit up all the vendors here who can get the JDM parts and get quotes from all of them. The most frustrating thing is they all raises the prices when the dollar loses value compared to the yen, but they conveniently never adjust it back when the dollar gains against the yen. Shop around for the rear, side, and whatever front piece you decide on. Ordering multiple things at once usually can get you a better deal.