yes i agree.. the cutting of the floor scares the heck out of me.

 

Looks good, nice install

 

so the stock hoops are not enough roll over protection? is it regulation to have a roll bar like this.

 

best first mod for any noobie

 

Nice choice on first mod. I went down the same road as you.

Where does the lower harness bar sit in relation to the bulkhead? Is it absolutely necessary to remove bulkhead for access to the lower harness bar?

I have the welded diagonal and welded harness bar (higher placement). I'm at the point of adding seats shortly and getting harnesses. I'm wondering what I can do to keep the bulkhead for stock seatbelt use.

 

props for getting down to business

 

Looks good. I really want to pick up one of these in the near future. I didn't realize you had to cut quite as much of the interior panels as you did. I'd definitely want to keep the softtop shelf piece but I plan on ditching the factory roll hoops along with the center console/secret compartment.

 

Thanks for the nice comments guys.

If you notice, I chose to keep the rear shelf. It took some cutting and convincing but it worked

 

the requirement for roll bars for open top vehicles is spreading westward

 

Hey, I ordered my bar about a week ago. I was wondering, how long did it take you to receive your bar? Nice installation. Looks good!