Project Mu BBK Install with Advan RZs
Registered User
Joined: Jan 2005
Posts: 3,737
Likes: 0
From: Torrance
"the 355 rotor needs to be spaced out by a tad in order to clear"
What part of the car did it need to clear?
Looks great BTW! Much better the previous version Pro Mu's with full Windows 95 blue anodized
What part of the car did it need to clear?
Looks great BTW! Much better the previous version Pro Mu's with full Windows 95 blue anodized
Thread Starter
Registered User
Joined: May 2007
Posts: 3,171
Likes: 0
From: Hawaii
Originally Posted by leester01,Mar 21 2009, 12:51 PM
"the 355 rotor needs to be spaced out by a tad in order to clear"
What part of the car did it need to clear?
Looks great BTW! Much better the previous version Pro Mu's with full Windows 95 blue anodized
What part of the car did it need to clear?
Looks great BTW! Much better the previous version Pro Mu's with full Windows 95 blue anodized
the rubber boot at the end of the tie rod, didn't want to split that sucker open (i'm assuming it's packed with grease, etc) after all the headaches, imma campaign to stop manufactures putting "AP1/2" on their products, a lot of stuff doesn't FIT!!!
lol @ windows 95 blue, brings back memories..
but yah, thanks for the comments everyone!
Thread Starter
Registered User
Joined: May 2007
Posts: 3,171
Likes: 0
From: Hawaii
got a few PMs about the brake line issue. i don't think there's an adapter that would make the project mu line fit onto ap2s, so for all you ap2 ppl out there with bbk, you all needed to run ap2 specific lines right?
i know many of the brake line boxes say ap1/2 on them, would suck to buy them and not have them fit...
i know many of the brake line boxes say ap1/2 on them, would suck to buy them and not have them fit...
