Yes, these are bling only. I want red under the hood

 

Got my hardware in very fast, happy now, i wonder when the side pieces will be out

 

Finally installed mine a few days ago. Install went very smooth. I was confused by the hardware when I took it out of the box weeks ago, but after looking at the bottom of the car and thinking, suddenly all was crystal clear. It's actually a very clever and simple installation design, and a one-person job. Very happy!

I'm not in the habit of 10/10ths cornering at 80 MPH on the streets, so I may have to wait until the next track day to actually enjoy any benefit from this, but I'll give it the thumbs up!

 

Hey what's the facebook group page again?

 

http://www.facebook.com/#!/pages/Gladman-Performance-Fabrication/207846395913080

 

i skipped out on the 1st group buy and now i regret it...in on the next one

 

Whats's the status on the rear side pieces?

Should I keep track of this thread or the one about gladman-performance-new-product-interest?

 

I will post a new thread when they're ready. I'm going to try and nail the side pieces down before the end of the week. I'll just need to confirm fitment/make modifications to fit the AP2 rear sides.

 

according to the guy who is trying to make rear fender liners, the rear bumpers are different and a piece that it meant to fit an ap2 will not fit the ap1.

 

Well have to look more into this, I held the side pieces up on Alex's AP2 a couple weeks back and they didn't look too far off, although there were definate differences.