Alright, so I am starting my preps to build my engine.
Reason for build: bent rod four and scored the side of the cylinder.
Step one, I need to pull the engine apart so i can send it out to get sleeved. Is there a DIY poost out there that could help me through this.
Step two, I need to find a reputable shop in the Hampton Roads area of VA. Anybody know a good shop for that?
Step three, while I have everything apart, should I do the F24 stroke using the prelude and tsx parts? Is it worth the effort?
Step four, i plan on putting the inlinePro turbo on after the engine build.
Step five, It will be boosted...so I would appreciate any recommendations for parts to throw in while i have the whole thing pulled apart, so i only have to do this once. I'm looking for reasons on why those brands/parts come recommended too.
Step six, is there anything I should watch out for while i do this?

Thanks for any advice....
Frank

 

i almost forgot, my end goal is to have a reliable daily driver with over 500whp. thanks

 

I would just look throught the FI section on this forum. Then, any information you can't find, I would post a different thread there.

 

Well, you could have posted in the Mid-Atlantic section and/or the Forced Induction section. Both of those would be better locations to ask these questions.

It also looks like you're trying to sell stuff, which requires you be a paid member of the site.

 

:takes out popcorn from microwave and pulls out a lawn chair:

 

glad to see that somebody else is entertained as well. At least i got SOME sort of direction from them.

 

 

Seriously WTF just happened? I don't see anything above that could be insulting or rude.

That is too bad Dueces... There is alot of info and helpful people on this forum.

 

thats what i was thinking and then you call members fags? if you dont want to come on this forum anymore then good, we dont need or want members like you to begin with

 

X2