Been awhile since I did an exhaust swap on my old AP1 (5 years). I know it isn't rocket science, but I cannot find torque specs for the exhaust and cat bolts....


If someone can assist, I'd appreciate it. Also, I am wanting to just use ramps for the swap versus jack and jack stands. Is it feasible to do it this way? I'll be open to either option, just wondering.

 

Exhaust/Cat bolt=25lbft
Exhaust/Spring bolt=16lbft

 

Confirmed in service manual.

 

Thank you, gentlemen.

 

Its easier to get at the rear hangers with wheels removed. So jack stands are easier. But it can be done on ramps. Just undo the rear hangers first, to see if you can do them with wheels still on. If you can't, at least you didn't get most of the way into it only to get hung up by the hangers.