I am ordering a Rockstar Garage roll bar tomorrow. I am looking into the Momo Daytona Evo seats. I am reading that the Sparco Evo / Evo plus may have to be mounted a bit off center so that they don't touch the door when it's closed. Anybody confirms/denies? By looking at the dimensions of the Evo plus, it looks like the Daytona Evo would fit. Does anyone has the Momo Daytona Evo? Any problem mounting your seat in the car that I should know off? Any recommendations? I will most likely use Schroth ClubMan 6 point harnesses, bolt-in, pull-up. I am all ears guys!

 

Any suggestion guys?

 

I believe the Sparco Evo fits fine as long as you remove the side plastic just behind the doors.

 

No answer here but I like what you're doing to the car!!

 

Thank you! I am not into modifying cars too much, but in this case, since I am tracking the car, it sounds like the right thing to do. AP1 with good rotors, lines and pads, that's it. No mod to the engine planned since I had a ride in a stock Miata (with race pads, Toyo Proxes tires and spec suspensions). The driver was insanely good and was competing with much bigger cars. I was so impressed of what he could do with his set up that I have a long way before the engine is the limiting factor...

 

Thank you, that's good to know. I guess it makes sense. I read a post where a guy had to mount the seat slightly off center ( ) so that it doesn't touch the door. Removing the side plastic sounds like what he could/should have done.