So i have a Buddy Club Prospec exhaust from my Rsx type s that is 65mm.

i was wondering would it be worth it to get the resonator and muffler cut off and custom piping done to fit right? i really liked the look and performance of this exhaust on my rsx.

i have been looking to sell it, but there seems to be limited interest and prices that are lower to what i would want to sell it for.

here are a couple pictures





do you guys think this would work, or would you just sell it and get something else?

 

damn, did i put this in the wrong area? lol im sorry if i did

 

I wouldn't hack up that exhaust to make a "custom" one that probably will not flow as good or perform any better than stock..

But that's just my opinion on it.. I'm sure some of the pros will give feed back tomorrow..

 

id say no, not worth the trouble

 

If you wanted to do it in Stainless it will not be worth the expense. Just save up for nice big 70mm+ system.

 

sell that one. lots of peopel have rsx's nowadays jsut like the s2k that are willing to mod em. after sellling it just get a 70+mm exhaust for s. i would recommend the berk technology one. it's a 3" and don't get all twisted up with back pressure crap either. the bigger the exhaust the moar power you will make. it's been proven a million times already lol

 

Excuse my "ignorance"

But do you really need a 3 inch exhaust for a NA car?? I thought bigger exhaust like that were best for forced induction..

 

^^ Do the 70mm for NA. If you have any plans for a turbo later, just do the 3 inch and be done with it. Sell the Buddy Club.

 

thanks a lot guys!


back up on the market lol