2.5" Custom Exhaust at Split - What Bends?
Thread Starter
Registered User
Joined: Oct 2013
Posts: 80
Likes: 0
2.5" Custom Exhaust at Split - What Bends?
Hey guys, been trolling on several exhaust threads and I think I want to do the custom 2.5" exhaust where guys cut at the "Y" and run a single pipe out the back.
Like this: https://www.s2ki.com/s2000/topic/873...t/page__st__75
The threads are several years old so no one is responding. Just wondering if any of you can remember what mandrel bends you used so I can order them and get an exhaust welded up.
Thanks much!
Like this: https://www.s2ki.com/s2000/topic/873...t/page__st__75
The threads are several years old so no one is responding. Just wondering if any of you can remember what mandrel bends you used so I can order them and get an exhaust welded up.
Thanks much!
Joined: Jun 2011
Posts: 1,040
Likes: 4
From: UMW
Thread
Thread Starter
Forum
Replies
Last Post