anyone else seen this car??

 

um.. it's a photochopped OEM S2000. the body's been stretched down to the ground, the JDM OEM BBS rims have been inflated to 19" size and stuffed into the wheel wells. not to mention those enormous brake rotors...

no i have not seen this photoshop car on the road.

 

looks photoshopped

 

i found it on the web a long time ago before i got my s2000 and i thot it was really lowered like that, i wish mine was

 

they did a good job, becuase the shadows match up and the rear tires seem to be a little taller than the front and the rotors dont look too big to me, just about right against a set of 19s.

 

don't mean to put insult to the artist, but it's a terrible photochop. the shadows match up because nothing was is protruding from the original length of the body. the shadow that's there is not a work of the artist but part of the original photo. the side skirts are terribly done. the artist used a stamp tool but failed at doing so. you can see the lines form the original photo where the side skirt was copied from. the front bumper is terribly done as well. there is a gap in the wheel well. normally if the bumper was that low, you wouldn't see to the other side if the shot is taken at that angle. this makes the bumper appear to be missing from the other half of the car. the rotors look like 14" rotors up front and 15" in the rear. far from realistic. the lens glare on the headlight is a cheesy touch.

not a good job to me

 

i just wish it was real

 

how many times do you park your car and take a picture when the wheels are exactly in the same direction with the stem at the same point at the bottom, haha

 

there's nothing that impressive about the car.

the wheels are JDM OEM BBS 16" wheels. the drop can be had with any coilover setup. the OEM front lip takes care of the front. the Airwalker sides look way better than that photoshopped junk. the rest of the car is OEM.

 

ive got air rods and can get close to an inch off the ground, but this car looks even lower, after seeing this ive got some machining (sp?) to do