what is the average wheel horsepower for an ap1 with cai, test pipe and single 63mm exhaust. On a dynojet. Just curious what some of you are putting down.

 

with short ram intake, comptech exhaust, ricks pullies, no cat, and v-afc I dynoed 209hp to the wheels with I think 147 tq.

 

I thought it was going to be much more than 209hp with all those mods.

Jason

 

Also depends on what type of dyno , if the numbers above were from a mustang it would be damn good, but they are probably from a dyno jet???

 

ya dyno jet.... Im not positive what a base dyno looks like but it seems right to me exhaust 3 hp, no cat mayb 5-6, intake 5, pullies 4 mayb, vafc 6 hp by lowering vtec

 

ya because I just dyno'd 200.4whp and 137trq on a dynojet. I have an 01 with 40k miles. I just wanted to make sure that is in the relm of normal for my mods.

 

You're looking at about 205 rwhp. Stock should be around 200.

 

stock from what ive seen is around 185...200 seems a lot without any mods

 

ya stock I was at 190.5 and the curve was really really jagged then with mods more curve is nice and smooth. But still dropping after 8.5k I am going to try and upload graphs since they were done within a day or two of eachother.

 

I heard dyno jets make you run a slight less than what you are actually running at? I ran mine on the dyno jet and I ran 207whp with 145tq with testpipe/exhaust/intake. Everyone said they were running a little less than what they should be at so ...