Here are the results...



The first 2 runs were in 3rd gear and the last one was in 4th gear.

The only mods I have is the Berk Test Pipe and ARC Intake

Let me know what you guys think.

It was in San Bernardino, CA and temp was ~85 Degrees with low humidity...

 

Noticed that the peak hp is a bit lower than usual for an AP2, however the torque sounds about right. By the way did you tune the car or was it just a dyno run to see how powerful the car was?

 

This was just a straight Dyno with 3 runs. I just wanted to see how much power I was getting.....I told them just to do it up to 8100 RPM. Didn't want to go to the 8200 redline.

The last time they dyno'd a AP2 at there shop.... it had 205 HP.

 

what is a baseline dyno for the s2k on the dyno jet?

 

I don't know what it is but I've seen it range from 188-220 HP bone stock. AP2 suppose to be alittle higher in TQ. This is from what I have read and looked up on the boards.

 

nice numbers, i pulled 207 on a dynojet

 

Hey man,

Did you go down with MR2 Mike? Nice numbers. The last time I dyno'd my car it did 198 w/ the 60rs test pipe and j's intake.

But this was on a mustang dyno.

 

take that arc & u'll make more hp.

 

Nice # My ap1 pulled 211 on dynojet (temp was 101 inside the warehouse) Mods: AEM V2, test pipe, hondata gasket and SAFC tuned.

 

Hey man whats up!

Yeah I went with MR2 Mike.....he pulled 260 HP and I forgot what his TQ was I think it was 220 but wasn't sure. Jon didn't do so well hehe. You can ask him

Hey you got pretty good numbers if it was on a Mustang Dyno. Not bad But you will have more HP than me if it was on a Dynojet