spoon or proflow
Registered User
Joined: Oct 2000
Posts: 3
Likes: 0
A staight bore TB is always make more power at high rpm but you will lose the bottom end.
As for Spoon TB, they are only taper design so mid-range will be better but paying 300-400 for Spoon doing the work is a little too much . I can have your bore out for only 150-200 so if you are interested you can email privately.
As for Spoon TB, they are only taper design so mid-range will be better but paying 300-400 for Spoon doing the work is a little too much . I can have your bore out for only 150-200 so if you are interested you can email privately.
Thread
Thread Starter
Forum
Replies
Last Post