Locking vtec for cam degree-ing
#1
Thread Starter
Locking vtec for cam degree-ing
Hi all
Are there any genius' in here who can advice on locking the rockers together so that I can degree my cam setup on the vtec lobe?
(skunk2 tuner2 cams + skunk2 cam gears)
I've seen on B16s it looks easy, just reverse the pins but I can't figure out a way that works on the F20, some talk of utilising ball bearings too but agin no luck with this method, IM terrified of dropping something into the motor !
Also there looks to be a method with compressed air, but I don't have a compressor or fittings.
The following users liked this post:
Slowcrash_101 (06-24-2022)
Thread
Thread Starter
Forum
Replies
Last Post