Setting the EPS torque sensor neutral position

Reply Subscribe

Thread Tools

Dec 13, 2004 | 06:49 PM

#11

Squeezer

Registered User

Joined: Oct 2000

Posts: 2,307

Likes: 1

From: Jackson

Quote:

Originally Posted by mtm584,Dec 13 2004, 06:13 PM

Ok lets see if i got this right when the i short the scs and the cel starts blinking i go thru the steps to set the neutral postion?

yes doing this http://www.baustnet.com/honda/misc/dtc.htm to blink the CEL light is the same thing as using the honda PGM tester to short the SCS connector. so you would short it and then follow the instructions on page 17-45 of the helm service manual. it would probably be easier to connect a switch to short the wires, but you could probably do it with a paperclip if you really had to. or use a t-tap on the SCS wire like modifry says you can do.