so i just had my fenders rolled but smirfs2k05, he's done a LOT of fender rolling and it was obvious he knew what he was doing.

anyway paint seems to be peeling on a 1in long area at the fold, on the rear quarter.

is there anyway i can keep it from peeling like crazy? i was thinking i could sand it down slightly and brush on some touch up paint.

 

damn, that sucks...

 

Sucks, but extremely common with rolled fenders...

 

roll it to the max that you want it, then get a shop to paint over

 

that's what i was thinking, there another dent in the door jamb area on that same panel. can they paint that 1 panel and get a near perfect match? it's an '05 btw

 

yup, once the paint cracks its a repaint-
a good shop will be able to match the paint.

 

you can put clear nail polish on it to stop the chipping. thats what i did and its been holding up for one year.

 

he used a heat gun to roll em?

 

yeah he used a heat gun

this being the only spot where cracking occurred, i think he did a pretty damn good job

repaint time i guess

 

why not just sand down underneath to stop the cracking and use toucu up paint, its only underneath, kind of hard to see it