So my buddy and I are going to be installing a comptech supercharger on my s2000 here in a few weeks and I am in need of a couple things. Just wondering if anyone around town had a service manual, Crank Bolt Socket, and a Crank Pulley Holder Tool that they wouldn't mind letting me borrow for a week or so, maybe putting a deposit down or something for insurance. Thanks

Also, if anyone has installed the comptech s/c before, any advise would be greatly appreciated. I have been through the instructions and every DIY from every member on s2ki that I could find, so I am fairly sure I know when, and where the install will become difficult, but you know...Thanks again!

-Michael

 

Where will you be doing the install. I happen to have all of the above, but don't have experience installing the comptech blower, yet, and would like to look over your shoulder.

 

Thats cool man..I would like to watch and learn as well..

are you gonna run off the fmu?

 

Well the install will be done in Houston, I'm only in San Antonio for school. And I might not even be part of the install, it all depends on when my buddy finishes his engine build. And then I am not anticipating this being a one day install since the kit is used, I'm sure there will be something that goes wrong with it.

And mr. GP, I should be getting an Emanage Ultimate for tuning, and getting it tuned in Houston somewhere.

And Justin, would you be willing to loan out those parts/manual to me?

Thanks for looking

-Michael

 

Yes, I would be willing to loan them to you. I would need a deposit and you would have to come pick it up in person.

 

hey, when are you planning to do the install? I'm kinda curious as well. I'm in austin for school and will be back in houston after finals.