This is a follow-up to prevent hijacking a different thread. Just sharing the opportunity since some others showed interest or were just plain bored Saturday before college football games start.

I'm tuning my S at Kwik Kar in Richardson Sat 10/22 from 8 - 10:30 (or later depending on how long the shop techs take between runs). I reserved it for this slot since I may need some cool-down and want to avoid being rushed while I program fuel and ignition curves into the AEM via laptop. Kwik Kar's a very clean facility where I've done all my testing (for consistency's sake).

Kwik Kar is near the SW corner of Jupiter and Campbell in Richardson. Phone number is 972-644-1851, address is 1851 Jupiter Rd Richardson TX 75082.
Dynojet 248c if memory serves.
Was priced around $35 w/o air-fuel - $45 with air-fuel for 3 pulls last time I was there.
YMMV; please understand if the pricing changes through the lifecycle of this thread.

 

I pass through there often and never knew they had a dyno there.

 

I used them once recently, and liked the shop and setup. It cost me $50 for 3 pulls w/AFR measurements. Wish I could be there... but I'm in CO now. Going to 2nd Creek tomorrow to give it a proper send off.

 

Hell i got nothing to do, ill go there tomrrow morning and Dyno my car too. Been kinda feeling that my car is slow. Curious to see if ive lost horse power.

 

Went there to dyno and i saw a red S2000 on there for 4-5 hours straight. Ended up going to Intercrew for $50 3 pulls.

 

Not surprised...did you read his original post?

 

Yeah, didnt know it wouldve taken that long lol. Imma newbie when it comes to knowledge about turbo tuning. 7 hours is a long time which I didnt expect. Anyways it was a nice Red S. Nice rims and nice exhuast.