Diagnostic pulls - flashpro
04-30-2014, 10:57 PM
#1
Registered User
Thread Starter
Join Date: Apr 2012
Location: Liverpool
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Diagnostic pulls - flashpro
I have purchased a flashpro and will be having my car tuned by Gernby from the US S2Ki forum,
He's sent me 7 calibrations I need to datalog which I'll then send back to him so he can analyse and work his magic,
My problem:
I need to do them all on the same run,
Basically load a calibration, make 3 runs, unload cal and then load the next one, make 3 runs etc etc
Any idea where I can do this in the north west?
Ideal road would be a dual carriageway with an island at either end ( to spin round) and have somewhere safe to pull over and load/ unload calibrations.
Ideally not to far from Liverpool
Graham
Sent from my iPhone using Tapatalk
He's sent me 7 calibrations I need to datalog which I'll then send back to him so he can analyse and work his magic,
My problem:
I need to do them all on the same run,
Basically load a calibration, make 3 runs, unload cal and then load the next one, make 3 runs etc etc
Any idea where I can do this in the north west?
Ideal road would be a dual carriageway with an island at either end ( to spin round) and have somewhere safe to pull over and load/ unload calibrations.
Ideally not to far from Liverpool
Graham
Sent from my iPhone using Tapatalk
05-01-2014, 01:38 AM
#2
I have purchased a flashpro and will be having my car tuned by Gernby from the US S2Ki forum,
He's sent me 7 calibrations I need to datalog which I'll then send back to him so he can analyse and work his magic,
My problem:
I need to do them all on the same run,
Basically load a calibration, make 3 runs, unload cal and then load the next one, make 3 runs etc etc
Any idea where I can do this in the north west?
Ideal road would be a dual carriageway with an island at either end ( to spin round) and have somewhere safe to pull over and load/ unload calibrations.
Ideally not to far from Liverpool
Graham
Sent from my iPhone using Tapatalk
He's sent me 7 calibrations I need to datalog which I'll then send back to him so he can analyse and work his magic,
My problem:
I need to do them all on the same run,
Basically load a calibration, make 3 runs, unload cal and then load the next one, make 3 runs etc etc
Any idea where I can do this in the north west?
Ideal road would be a dual carriageway with an island at either end ( to spin round) and have somewhere safe to pull over and load/ unload calibrations.
Ideally not to far from Liverpool
Graham
Sent from my iPhone using Tapatalk
There's Efi Parts over in Widnes Runcorn area - Chris is pretty clued up too
Thread
Thread Starter
Forum
Replies
Last Post
