hey just posted this in the main forum need help urgently

the car is an 00 f20 bog standard!

engine power 209.4bhp
wheel power 146.8bhp
torque 175.6nm

as the car hits v-tech you can hear it come in but on the graph the torque stays at around 160 and doesnt go up im stumped to be honest, any ideas welcome please cheers

 

checked the oil level?

no mention of sh, mileage, etc.

 

upload the graph as well.

 

Spark plugs, vtec solonoid!!!

 

Don't believe everything you read on a dyno printout.

I have seen 140 - 210wp, for NA cars, on dyno graphs and *every* dyno operator will claim that their dyno is right.

 

was just going to say the same as eSem

why dyno was it on aswell

 

80k on the clock full honda service history

 

As the crossover of power/torque is 7k and not near to 5200rpm, there is something seriously amiss with the dyno calculations, as technically its impossible!

E.G HP = Torque * RPM/5252

Go to someone who knows what they are doing?

 

Heat soak.

 

I think 'VTech' equipment was used by Gordon your inspector.