looking for completely trashed cylinder heads and blocks. Need for mocking up a f20c based v8 engine design. Hoping to find parts cheap, or as a donation. will pay shipping. Also need timing components like upper timing gear, chain, and guides.
Thanks
Steve Mardell

 

how much are you paying? i can get both but theyre not THAT trashed to the point where they are free.

 

trying not to pay more than 100$ as I am going to be cutting the blocks in half and welding them together to get a full size model for mock up and measurement. Need the cylinder heads to fit on the block for fitment in the s2k engine bay and measure timing components.

 

sorry then can't help you.

I could do 350 per head or 300 per bare head. (since u said u need timing components, i assume cams are needed)
and 250 for a block with scores up and down.

 

cams are not needed, just idler gear. the prices are fair. but too much for what I will be doing with them. Once I prove my design works then I will be buying useable cylinder heads. Thanks for the reply though.

 

well are you a machinist by chance? i would trade for services depending on what you're qualified for. power hungry here

 

yes I am a machinist and mechanical drafter. what type of work are you looking for? my project is a common block, bolt on cylinder banks like that of a motorcycle, 2 f20c cylinder heads drivers side cylinder bank turned around 180 degrees with timing chain near firewall. 84mm stroke 90mm bore. Yeilds 4275cc's, or 4.2 liters. The only reason i need 2 blocks is for a full size mock up, i will not be using anything oem. This is just to weld 2 blocks together put heads on it and see if it will fit in the engine bay. also will be using the block to make sure the rear timiing chain drive will work like designed.
this guy john hartley from www.h1v8.com did it with busa motors. my design is a true 90 degree v angle using f20c geometry.
im designing and hoping to produce a kit built engine to drop in the s2k. doing what honda won't

 

Steve,

Give GT Motoring a call (or drop them a PM at "jwkim" and/or "J's Racing"). They may have what you need, or could potentially source what you need.

They may even be inerested in the outcome of your efforts.

Tell them Luder94 (Urmil) sent you.

 

AP1 Motor Parts

This motor came out the 2000 AP1 we bought to build as a race car for the 09 season. Chassis has about 100k miles on it.

The car never got the spark plug recall done and dropped spark plug bits in the cylinder. Everything else is good. Photos show any damages. The block might be serviceable as only one cylinder has a tiny score. The piston will need to be replaced. Crank, rods oil pan etc all included and assembled as shown. Includes oem ap1 flywheels and clutch assembly.
$600 plus shipping

The head will require some repair for proper usage as the dome has markings. No cams or rocker assembly included.
$190 shipped

Thottle body $150 shipped
injectors $100 shipped
fuel rail $35 shipped
intake mani $100 shipped

 

meh, i think we can work something out OP. you have PM.