Location: Lakewood, Ca
Means of Contact: PM or jdotlim@gmail.com

Description:
SSR Type F

18x9 +32
18x9.5 +35
No Valve Stems or Center Caps
Original Boxes INCLUDE

CONCAVE FACE on all 4 wheels.

No Bends or Cracks! Just scratches and small rashes.

Price: $1100 FIRM til I have time to get them redone.

Was going for a meaty fitment, but when I test fitted its not going to work because I pulled my fenders. So it will be sunk into the fenders too much. These will for sure need powder coating or some kind of finish. It's not super bad but you can see in the close up there is a lot of scratches. Hence the cheap price. These wheels weigh nothing compared to my Work Emotion CR Kai's. Remember these are not in the best condition.

Trades are welcome, no OEM, RPF1, NT03s. Prefer 3-piece.

 

You must have pulled the heck out of your fenders if these are too sunk!

GLWS.

 

Yea really LOL mine are pulled a bit and 17x9 +38 with 255/40 barely fits.. GLWS wish I had the cash i'd pick these up..

 

haha yeah, i pulled it to fit 9.5 +20. it was a minor pull, but even with the camber back to normal, it wasnt the fitment i was looking for.





Thanks!

 

Found a set of wheels I want. Offer!

 

pics on the car?

 

never installed it on my car, just did a test for. but google "SSR Type F S2000 Concave" there's a red one that has almost the same sizing. And it's concave face too

 

price lowered

 

What mods would need to be done to fit these? Only rolled all around with 1.5 drop.

 

As long as you're rolled flat. I would run 225/40 rear and 215/40 front. Run camber, and you should be good. Check this link. Similar sizing.

http://www.rimtuck.com/setup/view/1743