Mark this thread as Unsold
OEM CR Wing w/Trunk
10-14-2016, 01:35 PM
#1
OEM CR Wing w/Trunk
OEM CR Wing and OEM Trunk LBP
Contact: PM
Location: Orlando, FL
Price: $1300
OEM CR Wing with an OEM drilled and reinforced trunk. It was a standard trunk lid, not a CR lid. The keyhole has been shaved, but Honda badge remains.
I drilled the trunk with the proper mounting location for the OEM CR wing holes, and used rubber gaskets and fender washers to prevent any bowing of the trunk lid or water leaks. I’ve had the car out in multiple Florida rain storms with zero water leaks, and the wing has seen 142mph (GPS) at Daytona International Speedway without issue.
I installed all the extra rubber supports that the CR comes with. All were installed in OEM locations.
The wing and trunk were painted LBP and the paint is essentially flawless.
For those who know me, they know I took a ton of time lining things up to ensure this is as close to OEM as possible.
It will be a PITA to ship this, but I'd be willing to drive to meet up with someone a reasonable distance.
The rear light has surface scratches. Should be able to be buffed out.
All OEM CR trunk feet are on the trunk lid. Purchased new from Honda.
A picture of the visible fender washer. All 6 mounts have fender washers installed.
This was taken when I assembled the wing/trunk.
Contact: PM
Location: Orlando, FL
Price: $1300
OEM CR Wing with an OEM drilled and reinforced trunk. It was a standard trunk lid, not a CR lid. The keyhole has been shaved, but Honda badge remains.
I drilled the trunk with the proper mounting location for the OEM CR wing holes, and used rubber gaskets and fender washers to prevent any bowing of the trunk lid or water leaks. I’ve had the car out in multiple Florida rain storms with zero water leaks, and the wing has seen 142mph (GPS) at Daytona International Speedway without issue.
I installed all the extra rubber supports that the CR comes with. All were installed in OEM locations.
The wing and trunk were painted LBP and the paint is essentially flawless.
For those who know me, they know I took a ton of time lining things up to ensure this is as close to OEM as possible.
It will be a PITA to ship this, but I'd be willing to drive to meet up with someone a reasonable distance.
The rear light has surface scratches. Should be able to be buffed out.
All OEM CR trunk feet are on the trunk lid. Purchased new from Honda.
A picture of the visible fender washer. All 6 mounts have fender washers installed.
This was taken when I assembled the wing/trunk.
Thread
Thread Starter
Forum
Replies
Last Post