_Ninja_

So this is what one end of my propeller shaft is looking like:





GREASE EVERYWHERE fuuuuuuuuuuuuh.

So does anyone have that part at the end of the shaft, between the tranny (the one with the bolts around it)? Or the whole shaft itself?

1FastS2k

Supposedly, they are non serviceable but I'm curious if that is true. I had an extra one a couple of months back, but I threw it away because it was dented . I know driveshaft shop makes an aluminum one.

Subestile might have one and I think kyushin just replaced his too, not positive though.

unlewser

not helping, but just curious.

Could you tell it was broken? noises or vibrations. Is the only way to know its bad is to check it out visually?

SubeSTile

man i just sold mine and shipped it last week, they are not serviceable but a driveshaft shop may be able to rebuild it, there is a shop off 19th and deer valley that i ahve used before, really good work and decent price

DFWs2k

Ap1 or ap2 or are they the same? Whats the going rate?

Sent using free Tapatalk - Android FTW

1FastS2k

His looks like an Ap1 prop shaft and they are different.

I think I paid $100 shipped for my last one.

Kyushin

Yes there were noises but hard to say if it was the shaft alone. Had afew split mounts and diff just went to hell, but on deceleratoin at speeds under 10mph with the car in N, I could hear a very odd clunking from the back.

_Ninja_

I really want the aluminum one from drive shaft shop, but just can't drop $800ish right now :/

AP1. So far I haven't heard weird noises, but don't want to wait until that happens because that might be too late and I might blow the drive shaft off somewhere on the road and tow my car haha.

Well I'm still looking if anyone has one. Thanks!

alanpikku

That price is ridiculous! I would assume you can get an aluminum drive shaft costume made for much cheaper than that.

3en

Put my car on the lift today and found mine just blew. It was like a solid ridge of grease.