pinnacleliquid

That is if you consider what we do an upgrade. I know there are plenty of flat dash kits out ther for the S2K. We make them too. But we also have a higher end approach that I think may be more appropriate to this car. It's a more OEM look, a more integrated appearance. It is popular on many cars. I need a set of parts off someones car for about 4 days to apply our treatment. I will do one set free because I need to photograph it. (of course to hopefully sell more of them. It would be off a vehicle that is regularly shown at various venues. Pics below give you an idea of what we do.
Just PM me or email me at info@elegantwooddesign.com to be considered.

integrate

Exactly what would you replace in the S2000 with carbon fiber?

btw, is it real carbon fiber?

north9586

I might be able to do this! But I have the same questions as integrate. And are things being replaced? Or covered?
Thanks

~Andrew

pinnacleliquid

Sorry not to be clearer. It is not real carbon fiber. It is for lack of a better word a print. It is an OEM process. The woodgrains and other patterns used by automakers these days are done using this method. It is a form of 3D printing. go here for a better description. http://www.elegantwooddesign.com/indepthlook.htm and look around the site at the other cars we do. Note: preference will be given to a local resident to me. Around Anaheim Cal.

Kodokan_4

Do you do Carbon Fiber wrapping of parts?

There are some parts on my S2000 that I would like wrapped.

Here's some of the carbon/kevlar work I've got in the engine compartment:



I'd like to hear your ideas for the interior. I've got some interesting ideas, as well.


-Pete

pinnacleliquid

we only do flat work with real carbon fiber. We are not equipped to mold it. The interior pieces I had in mind were the console, and gauge area, maybe door handle bezels. We can do this to exterior parts too.

rworne

Schweet! Pergo for your dash

Kodokan_4

The print that you show in the second pic looks like the 1+1 CF pattern.

Are you able to make some 2+2 CF pattern prints?

-Pete

pinnacleliquid

yes, no examples to show yet though. this one has been most popular. there are two patterns shown above. the red is actually a black print over a base color of your choosing. base color can be yellow, blue, purple, whatever. it shows through clearly. the other is desighned to match carbon fiber more closely and looks best with black base color as the film is a silvery color.

Kodokan_4

I would like the print that looks like the 2+2 CF weave, but my interior color is red. Do you have an application that is not transparent? I don't want the red to show through, I want the parts to be similar to my real 2+2 CF parts.

-Pete