FYI: Where the spacers go with RC injectors
Thread Starter
Banned
Joined: Apr 2001
Posts: 1,595
Likes: 0
From: Milwaukee
FYI: Where the spacers go with RC injectors
Here is where the spacers go with rc injectors.
You can also use washers which is what is in the picture
You will need two here. There is two spots for these.
You will need two on each of these.
Here is what it would look like if you use Plug and play harness since the RCs are made for obd1 clips. They run about 65 dollars but are worth it to not hack the stock harness.
Here is a picture of the gaskets that are used.(Can be had at home depot for a dollar.
Also here is a picture of an AEM EMS 1012 as close as possible to get it into the stock location. Notice there is a little trimming to do on the kick panel
You can also use washers which is what is in the picture
You will need two here. There is two spots for these.
You will need two on each of these.
Here is what it would look like if you use Plug and play harness since the RCs are made for obd1 clips. They run about 65 dollars but are worth it to not hack the stock harness.
Here is a picture of the gaskets that are used.(Can be had at home depot for a dollar.
Also here is a picture of an AEM EMS 1012 as close as possible to get it into the stock location. Notice there is a little trimming to do on the kick panel
Registered User
Joined: Jun 2002
Posts: 625
Likes: 0
From: STL -> Tampa
Pic's from my recent search:
From Trip:
From ex-eclipse:
Notice the spacer at the bottom...on the left...missing from the right.
Link to the O-Rings: O-Rings by JohnZ
From Trip:
From ex-eclipse:
Notice the spacer at the bottom...on the left...missing from the right.
Link to the O-Rings: O-Rings by JohnZ
Thread
Thread Starter
Forum
Replies
Last Post
s2000isu
Archived Member S2000 Classifieds and For Sale
11
Jul 8, 2009 03:03 PM
Venomous S
Archived Member S2000 Classifieds and For Sale
3
Feb 12, 2006 05:53 PM