Hey everyone I am looking for a set of cams and intake for my AP1. Just a mild cam. I am not looking for anything to aggressive. I am looking to get 230-240WHP with all of this. What is the base power of an s2k? Around 205 whp?

What will be added with cams and intake

Tracysports header
Spoon N1 exhaust
BERK testpipe
70mm throttlebody
ported intake manifold
hondata intake gasket
spoon thermostat
spoon fan switch
bigger radiator
4.77 gears

Also considering:
spoon headgasket


I am just looking why you would recomend and your reasoning why. Any links would be great to for reveiws, dyno charts etc.

 

All of those mods will get you to about 210 rwhp... if you're lucky.

Here's what you do: T1R 70mm single, VAFC2 + tune, gut your trunk, 4.77s.

That's about 2K, and a very low 13 second car at around 220 rwhp.

 

Then what would be needed to get 230-240 whp?

 

j's/spoon/asm built engine

 

I will be building a motor and hopefully it will be done next summer. Hoping for the inlinepro 2.7kit. As of right now I just want to do bolt-ons to see what I can come up with, but 230-240 would be nice until then.

 

You're not going to hit that with just bolt ons. With 70mm single exhaust and tuning, you should be around 220. Anything else to add more power isn't going to be worth the price. You could get to 230 but it'll probably take you 4 thousand dollars.

Wait for a good set of cams to come out (who knows when/if that'll happen) or just go turbo.

 

talk to Ya@ Inline, about doing a stroker FI setup if your going to be spending coin anyways