Stroke the motor, its already 2.2. I don't want an even lower redline. I guess you mean build up the motor. Higher compression pistons, lighter connecting rods, a new crank with everything balanced and blueprinted.

 

They had only a few prototypes a while back. I heard rumor they may be developing them again to sell to the public.

I got lucky enough to find one of those early one's, and now it's in my baby. An amazing piece.

If money really is no concern then you cn have them build you one, or like AP2-2NV said ou could have Burn's stainless build you one.

 

HEY BRO, LONG TIME NOT TYPE

ANYWAY, HOW MUCH DOES THAT COST TO HAVE THEM WELD YOU UP A HEADER?

 

what up brotha? It's spring break so I've been busy kicking back and just going out before classes start up again. Gatta soak in the freedom while I have it .

I'm not sure how much it'll cost to have hytech mae this. I'd figure the thing that would cost the most would have been making the design from scratch. Since they already have done past prototypes, and build for other s2k owners I'd guess above 1K, but less then 2K. I'm willing to bet it'll cost around the same the J's would. Best thing would be to contact them.

 

Hytech, hytech, hytech!!! That is probably the route that I will be headed. Than Hyrrz will have someone rocking a similar setup to his with the 3inch exhaust as well.

 

Hytech or J's. First i'll do is save up some cash and get the Toda 2.4 liter stroker.